320
edits
(→PLIB) |
|||
Line 335: | Line 335: | ||
*** The absolute address can easily be copied and pasted with the above [[Howto:Build_and_run_FlightGear_on_Raspberry_Pi_4#Copy_Path(s)|Copy Path(s)]] method. This could be a large string, however the Terminal doesn't mind. | *** The absolute address can easily be copied and pasted with the above [[Howto:Build_and_run_FlightGear_on_Raspberry_Pi_4#Copy_Path(s)|Copy Path(s)]] method. This could be a large string, however the Terminal doesn't mind. | ||
** This will setup the build. | ** This will setup the build. | ||
* Enter the below command into the Terminal: | |||
** <code>make -j3</code> | |||
*** This will perform the compiling. | |||
*** The <code>-j3</code> argument will allow three of the Pi's cores to participate in the compiling process. | |||
* Enter the below command into the Terminal: | |||
** <code>make install</code> | |||
** PLIB will be installed into the '''source''' folder. | |||
{{not done}} | {{not done}} | ||
| {{not done}} | | {{not done}} |
edits