320
edits
(→PLIB) |
(→PLIB) |
||
Line 310: | Line 310: | ||
|- | |- | ||
| | | | ||
# Navigate the Terminal into the '''source''' folder. | |||
# Enter the below command into the Terminal: | |||
#* <code>git clone git://git.code.sf.net/p/libplib/code libplib.git</code> | |||
#** This will copy the needed source files into this folder '''source'''. | |||
# Enter the below command into the Terminal: | |||
#* <code>cd '''libplib.git'''</code> | |||
#** This will navigate the Terminal into the folder '''libplib.git''' that was created and populated by the <code>git</code> command. | |||
# Enter the below command into the Terminal: | |||
#* <code>echo "1.8.6" > version</code> | |||
#**This will edit the file 'version' that is in this folder. This file can also be modified with a text editor, even via a GUI. | |||
# Enter the below command into the Terminal: | |||
#* <code>sed s/PLIB_TINY_VERSION\ \ 5/PLIB_TINY_VERSION\ \ 6/ -i src/util/ul.h</code> | |||
#** This is some complicated version editing. | |||
# Enter the below command into the Terminal: | |||
#* <code>git commit --all --message "Increase tiny version to 6."</code> | |||
#** More version patching stuff. | |||
# Create a folder named '''build-plib''' and have it placed in the '''source''' folder. | |||
#* The <code>mkdir</code> command or a GUI method can be used to create this folder. | |||
#* In other words; '''FlightGear/source/build-plib''' | |||
# Navigate the Terminal into the '''build-plib''' folder that was just created. | |||
# Enter the below command into the Terminal: | |||
#* <code>cmake -D CMAKE_INSTALL_PREFIX:PATH='''fg-install''' '''libplib.git'''</code> | |||
#** The two folders '''fg-install''' and '''libplib.git''' need to be replaced with the relative or absolute address of these folders. Use your favorite method. | |||
#** The absolute address can easily be copied and pasted with the above [[Howto:Build_and_run_FlightGear_on_Raspberry_Pi_4#Copy_Path(s)|Copy Path(s)]] method. This could be a large string, however the Terminal doesn't mind. | |||
#* This will setup the build. | |||
# Enter the below command into the Terminal: | |||
#* <code>make -j3</code> | |||
#** This will perform the compiling. | |||
#** The <code>-j3</code> argument will allow three of the Pi's cores to participate in the compilation. | |||
# Enter the below command into the Terminal: | |||
#* <code>make install</code> | |||
#* PLIB will be installed into the '''source''' folder. | |||
{{not done}} | {{not done}} | ||
| {{not done}} | | {{not done}} |
edits