Boeing 777-200: Difference between revisions

Jump to navigation Jump to search

Boeing 777-200 (view source)

Revision as of 13:48, 4 April 2014

468 bytes removed ,  4 April 2014
m
Remove VOR navigation frol LOC part
m (Remove VOR navigation frol LOC part)
Line 59: Line 59:
* '''Altitude selection''' (AUTO/1000) - Switch between automatic incrementing (AUTO) and incrementing by the thousands (1000)- this setting only helps when selecting the altitude via the knobs, this won't apply if using the Autopilot Settings dialog
* '''Altitude selection''' (AUTO/1000) - Switch between automatic incrementing (AUTO) and incrementing by the thousands (1000)- this setting only helps when selecting the altitude via the knobs, this won't apply if using the Autopilot Settings dialog
* '''HOLD''' - Engage/disengage altitude hold mode
* '''HOLD''' - Engage/disengage altitude hold mode
* '''LOC''' - Track NAV1 VOR, flying by the heading given by the NAV1 radial
* '''LOC''' - Track LOCALIZER, flying by the heading given by the localizer
* '''APP''' - Arm the ILS localizer and glideslope (laterally and vertically). Any current AP mode (HDG and ALTITUDE HOLD) remains active, until the NAV receiver captures the localizer or glideslope.
* '''APP''' - Arm the ILS localizer and glideslope (laterally and vertically). Any current AP mode (HDG and ALTITUDE HOLD) remains active, until the NAV receiver captures the localizer or glideslope.
* '''A/P''' - Engage/disengage autopilot
* '''A/P''' - Engage/disengage autopilot
Line 76: Line 76:
HDG SEL: follow the heading set on counter. Change value when HDG HOLD or press SEL button when other mode such as VNAV, LOC mode. Once reach to setting heading change to HDG HOLD.
HDG SEL: follow the heading set on counter. Change value when HDG HOLD or press SEL button when other mode such as VNAV, LOC mode. Once reach to setting heading change to HDG HOLD.
LNAV: follow the activated route.
LNAV: follow the activated route.
LOC: when arming, keep previous mode and then capture ILS or VOR course, follow that course.
LOC: when arming, keep previous mode and then capture LOCALIZER, follow that course.
 
Eg: VOR course capture.
 
Location->Position Aircraft On Ground. Enter RJAA to Airport and select Ranway 16R then press OK.
Equipment->Radio settings <F12>, Set 114.50 of KZE VOR frequency to Nav1 and set radial 260.
Take off and once ship is steady then AP on and set heading 220.
Press LOC button.
Select EFIS control knob to VOR and VOR L on.
Once you get to near cause of VOR AP changes to VOR mode then ship follows VOR radial as long as signal healthy.


Vertical control
Vertical control
Hyde
15

edits

Retrieved from "https://wiki.flightgear.org/Special:MobileDiff/69488"

Navigation menu