Engineered materials arresting systems

From FlightGear wiki
Jump to navigation Jump to search

Engineered Materials Arresting Systems (EMAS)

"Aircraft can and do overrun the ends of runways, sometimes with devastating results. An overrun occurs when an aircraft passes beyond the end of a runway during an aborted takeoff or while landing. Data on aircraft overruns over a 12-year period (1975 to 1987) indicate that approximately 90% of all overruns occur at exit speeds of 70 knots or less and most come to rest between the extended runway edges within 1000 feet of the runway end.

[...]

An EMAS is designed to stop an overrunning aircraft by exerting predictable deceleration forces on its landing gear as the EMAS material crushes. It must be designed to minimize the potential for structural damage to aircraft, since such damage could result in injuries to passengers and/or affect the predictability of deceleration forces. An EMAS should be design for a 20-year service life.

An EMAS is located beyond the end of the runway and centered on the extended runway centerline. It will usually begin at some setback distance from the end of the runway to avoid damage due to jet blast and undershoots. This distance will vary depending on the available area and the EMAS materials." (Source: FAA 150-5220-22A Advisory Circular)

Emas.png

EMAS on FAA airport charts

Here is an example how EMAS is marked at end of runway on airport charts (EMAS at KMDW, Chicago Midway International, RWY 22L, 346 x 170) Emas marked on chart.png

Articles

ESCO’s EMAS Safely Stops Regional Jet After Aborted Takeoff

Sources

http://www.faa.gov/documentLibrary/media/advisory_circular/150-5220-22A/150_5220_22a.pdf