652
edits
(Blanked the page) |
(→Quick Check for FGFS 3.0 Scenery 2.12 problems: new section) |
||
Line 1: | Line 1: | ||
== Quick Check for FGFS 3.0 Scenery 2.12 problems == | |||
'''''This is a proposal -- not yet final:''''' | |||
It seems with FGFS 3.0 and scenery 2.12 many users are running into problems and try now to debug/tune there system. In the meantime there are many very good and detailed wikis available (which then reference to even more detailed wiki). e.g.: | |||
* http://wiki.flightgear.org/Howto:Debugging_FlightGear_Crashes | |||
* http://wiki.flightgear.org/System_Crashes | |||
* http://wiki.flightgear.org/Howto:Improve_framerates | |||
* http://wiki.flightgear.org/Unexpected_Crashes_with_Scenery_ver.2 | |||
But I am afraid not everybody will really read them all - so let me give you some hints - and if you want more details see the wikis! | |||
You should start with a rather "complex plane" on a rather "complex airport" <small>''(e.g. EDDF, KSFO, etc.)''</small> when there is much traffic active -- of course you should stay OffSide on an unused parking-lot and inform ATC about what you are doing and watch MPchat! Then: | |||
* Before starting to tune set the frame-rate to the default 60 and activate <small>(see: View -> Rendering Option -> Throttle frame rate)</small> - then the actual frame-rate will be shown in the lower right corner of your screen. The goal should be to have '''''at least 20'''''! ''(With "my" Concorde at EDDF I am also satisfied with 10 - but for e.g. a dogfight you certainly need more!)'' | |||
* Try several rendering options and see how much influence they have: | |||
: View → Rendering Options | |||
:* Use the "Reload Scenery” button at the bottom to make sure all of the current scenery is loaded and shown | |||
:**set Animated Jetways →off | |||
:**set Custom Settings → off | |||
:**3D Clouds → usually may remain on (but you should try) | |||
:**Atmospheric light scattering → did not have a big influence for me | |||
* View --> Adjust LOD Ranges | |||
:LODs '''(Level Of Detail)''' have of course a very big influence - especially while moving! Because the scenery-tiles for scenery 2.12. became much bigger - they need of course lots of more PC and Video-Card and Memory power to display them! If your frame-rate is marginal, try to adjust a little during a full approach from at least 20 mi out, all the way down to the terminal and watch also other planes when they become visible! | |||
: There are 4 levels of details defined -- and you define at what distance the different levels shall be used - and thus you define how much more or less data your system must work with! The default settings are: | |||
:*Detailed = 1500 m | |||
:*Rough = 9000 m | |||
:*Bare = 30000 | |||
:*AI = 10000 (i.e. do not try to spot an aircraft further out than 10 km) | |||
* At the end I suggest: | |||
:#set the frame-rate a little lower then the average shown - that will prevent from erratic changes that may irritate you and may even crash your system! | |||
:# If you have disabled or changed some values, decide if you want to keep the changed values or change them back | |||
If that all did not help: Remember the wikis named at the top for much more tips and details. |
edits